Changes

The contents of the keyslot specified in REG_AESKEYCNT can be updated by consecutively writing four words to REG_AESKEYXFIFO (keyX), REG_AESKEYYFIFO(keyY), or REG_AESKEYFIFO (normalkey).

The contents of the keyslot specified in REG_AESKEYCNT can be updated by consecutively writing four words to REG_AESKEYXFIFO (keyX), REG_AESKEYYFIFO(keyY), or REG_AESKEYFIFO (normalkey).

After writing to a keyslot when that same keyslot is already selected via REG_AESKEYSEL, the keyslot must be selected again(write REG_AESKEYSEL + set REG_AESCNT bit26), in order for the AES engine to use the new key-data.

After writing to a keyslot, the keyslot must be selected again(write REG_AESKEYSEL + set REG_AESCNT bit26), even when writing to the same keyslot. Writing the last word to a key FIFO immediately after selecting a keyslot will not affect the keyslot keydata that gets used at that time, the new keydata will not get used until the keyslot gets selected again.

Writing to the key FIFOs with byte writes results in the AES engine converting the byte to a word for setting the key word, with this: word = (byteval) | (byteval<<8) | (byteval<<16) | (byteval<<24). The result is the same regardless of which FIFO register byte was written to.

Writing to the key FIFOs with byte writes results in the AES engine converting the byte to a word for setting the key word, with this: word = (byteval) | (byteval<<8) | (byteval<<16) | (byteval<<24). The result is the same regardless of which FIFO register byte was written to.