Difference between revisions of "Config Services"
Jump to navigation
Jump to search
Line 150: | Line 150: | ||
| 0x08120000 | | 0x08120000 | ||
| [[CfgI:DeleteCreateNANDSecureInfo|DeleteCreateNANDSecureInfo]] | | [[CfgI:DeleteCreateNANDSecureInfo|DeleteCreateNANDSecureInfo]] | ||
+ | |- | ||
+ | | 0x08130000 | ||
+ | | [[CfgI:VerifySigSecureInfo|VerifySigSecureInfo]] | ||
|- | |- | ||
| 0x08140042 | | 0x08140042 |
Revision as of 17:39, 2 August 2014
Config services
Command Header | Available since system version | Description |
---|---|---|
0x00010082 | GetConfigInfoBlk2 | |
0x00020000 | SecureInfoGetRegion | |
0x00030000 | GenHashConsoleUnique | |
0x00040000 | 3.0.0-5 | GetRegionCanadaUSA |
0x00050000 | 5.0.0-11 | GetSystemModel |
0x00060000 | 6.0.0-11 | GetModelNintendo2DS |
0x00070040 | 7.0.0-13 | (u8 val) This writes the input u8 to the first byte in the config-block for blkID 0x00160000. |
0x00080080 | 7.0.0-13 | (u32 value, u8 type) This goes through a table containing 5 entries, each entry is 2-words. Type0: compare entry-word0 with input value, on match write entry-word1 to cmdreply+8 output. Type1: compare entry-word1 with input value, on match write entry-word0 to output. |
0x00090080 | 7.0.0-13 | (u16 index, u16 value) This writes the specified value into the entry[inputindex], for the table with 0xBB entries listed below. The input index must be <0xBB. |
0x000A0040 | 7.0.0-13 | (u16 value) This goes through a table containing 0xBB entries. When an entry is found containing a 2-byte value matching the input 2-byte value, the u16 index is written to cmdreply+8. When no match was found, the output index is value 0xFF. |
Config service "cfg:s"
Command Header | Description |
---|---|
0x04010082 | GetConfigInfoBlk8 |
0x04020082 | SetConfigInfoBlk4 |
0x04030000 | UpdateConfigNANDSavegame |
0x04040042 | GetLocalFriendCodeSeedData |
0x04050000 | GetLocalFriendCodeSeed |
0x04060000 | SecureInfoGetRegion |
0x04070000 | SecureInfoGetByte101 |
0x04080042 | SecureInfoGetSerialNo |
0x04090000 | UpdateConfigBlk00040003 |
CfgS command 0x04060000(SecureInfoGetRegion) is used by NIM module to determine the SOAP RegionId, when sending SOAP requests. See here.
Config service "cfg:i"
Command Header | Description |
---|---|
0x04010082 | GetConfigInfoBlk8 |
0x04020082 | SetConfigInfoBlk4 |
0x04030000 | UpdateConfigNANDSavegame |
0x04040042 | GetLocalFriendCodeSeedData |
0x04050000 | GetLocalFriendCodeSeed |
0x04060000 | SecureInfoGetRegion |
0x04070000 | SecureInfoGetByte101 |
0x04080042 | SecureInfoGetSerialNo |
0x04090000 | UpdateConfigBlk00040003 |
0x08010082 | GetConfigInfoBlk8 |
0x08020082 | SetConfigInfoBlk4 |
0x08030000 | UpdateConfigNANDSavegame |
0x08050000 | DeleteConfigNANDSavefile |
0x080C0042 | SetLocalFriendCodeSeedSignature |
0x080D0000 | DeleteCreateNANDLocalFriendCodeSeed |
0x080E0000 | VerifySigLocalFriendCodeSeed |
0x080F0042 | GetLocalFriendCodeSeedData |
0x08100000 | GetLocalFriendCodeSeed |
0x08110084 | SetSecureInfo |
0x08120000 | DeleteCreateNANDSecureInfo |
0x08130000 | VerifySigSecureInfo |
0x08140042 | SecureInfoGetData |
0x08150042 | SecureInfoGetSignature |
0x08160000 | SecureInfoGetRegion |
0x08170000 | SecureInfoGetByte101 |
0x08180042 | SecureInfoGetSerialNo |
Config service "cfg:u"
This only handles the commands listed under the above "Config services", no additional commands.
Config NVRAM service "cfg:nor"
Command Header | Description |
---|---|
0x00010040 | Initialize |
0x00020000 | Shutdown |
0x00050082 | ReadData |
0x00060082 | WriteData |
This is an interface for the "SPI::NOR" service, for accessing the Wifi NVRAM/SPI Flash.