373
edits
Changes
Jump to navigation
Jump to search
mLine 293:
Line 293: − +
(oops)
| This is used to send over the shader program operand descriptor table.
| This is used to send over the shader program operand descriptor table.
|-
|-
| 0x000F5000
| 0x000F0050
| First entry
| First entry
| This command is used to setup shader output registers. The n-th word-long entry is a map of the (n*2)-th output register's components. Each byte of each entry corresponds to where a component is mapped. Value 0x1F indicates that the corresponding component is unused.
| This command is used to setup shader output registers. The n-th word-long entry is a map of the (n*2)-th output register's components. Each byte of each entry corresponds to where a component is mapped. Value 0x1F indicates that the corresponding component is unused.