Bootloader

From 3dbrew
Jump to navigation Jump to search

When the 3DS does not find the NAND chip, the following error is displayed:

CTR Bootrom Error.jpg

NAND Reads

During a successful boot on 6.x, the bootloader reads the following sectors from NAND (in this order):

00000000
0B130000
0B530000
0B130000
0B130200
0B163E00
0B193E00
00013000
00014000
00015000
00016000
00017000
...

The 3DS' Boot procedure:

  • 0 Seconds - unit is powered on the ARM9 and ARM11 bootroms begins execution
  • 2 Seconds - ARM9 bootrom attempts to initialize the NAND. If the NAND is successfully initialized, the ARM9 bootrom loads the firmware stored in the NAND FIRM partition which handles booting the rest of the system(if verification for NAND firm0 fails, the ARM9 bootrom will attempt to use firm1 instead). The ARM11 kernel loaded from FIRM then launches the CXI ARM11 system modules loaded from FIRM(Note that the ARM11 kernel does not handle any encryption/RSA verification, this is handled by the ARM9). If the NAND cannot be initialized, (i.e. the NAND chip is not connected/damaged etc) a blue error screen similar to the screen above appears.
  • 3 Seconds - all essential hardware is active. The PM module launches NS, NS then launches ErrDisp and the current active menu via PM module. For retail units this menu is usually the Home Menu. NS will auto-boot titles instead of launching ErrDisp/Home Menu, if auto-booting is needed. Note that PM module first launches the module dependencies when launching a process, prior to actually launching the process.
  • 4 Seconds - the LCD screens are initialized
  • 7 Seconds - Home Menu is fully initialized/loaded