Trusted
225
edits
Changes
Add and fix MCU-related battery and voltage info
| s
| s
| ro
| ro
| Battery temperature (in Celcius?)
| Internal battery temperature (in Celsius)
|-
|-
| 0x0B
| 0x0B
| s
| s
| ro
| ro
| Battery percentage
| Battery percentage (integer part).
Valid values are in range of 0 to 100 inclusive.
|-
|-
| 0x0C
| 0x0C
| s
| s
| ro
| ro
| Battery percentage, fractional part (seems to have a resolution of around 0.1% according to tests)
| Battery percentage (fractional part).
Seems to have a resolution of around 0.1% according to tests.
To calculate battery charge percentage in full resolution:
MCU[0x0B] + (MCU[0x0C] / 256.0F)
|-
|-
| 0x0D
| 0x0D
| s
| s
| ro
| ro
| System voltage
| System voltage.
This voltage seems to be measured at the load side, so the voltage reading will always be lower than direct probes across the battery due to the various voltage drops in the system by the time the voltage is measured.
To calculate system voltage in Volts:
MCU[0x0D] * 5 / 256.0F
|-
|-
| 0x0E
| 0x0E
byte 0x01: PMIC vendor code
byte 0x01: PMIC vendor code
byte 0x02: Battery vendor code
byte 0x02: Battery vendor code
0x00: Maxell
CTR-003 CTR-A-BP (old3DS)
CTR-003 CTR-A-BPMX-C3 (2DS): Wuxi Hitachi Maxell Co.,Ltd.
CTR-003 CTR-A-BPMX-C5 (Switch Pro Controller): Wuxi Maxell Co., Ltd.
SPR-003 SPR-A-BPMX-C3 (new3DSXL): Wuxi Hitachi Maxell Co.,Ltd.
byte 0x03: MGIC version (major?)
byte 0x03: MGIC version (major?)
byte 0x04: MGIC version (minor?)
byte 0x04: MGIC version (minor?)
byte 0x05: RCOMP(?)
byte 0x05: RCOMP(?)
byte 0x06: battery related? (seems to decrease while charging and increase while discharging)
byte 0x06: Battery middle terminal NTC reading (more heat causes this value to go *down*, and cooling off will make this value go back up)
byte 0x09: system model (see [[Cfg:GetSystemModel#System_Model_Values|Cfg:GetSystemModel]] for values)
byte 0x09: system model (see [[Cfg:GetSystemModel#System_Model_Values|Cfg:GetSystemModel]] for values)
byte 0x0A: Red Power LED mode (0 = off, 1 = on)
byte 0x0A: Red Power LED mode (0 = off, 1 = on)