6,264
edits
Changes
→I2C Devices
See the [http://www.alldatasheet.net/datasheet-pdf/pdf/347838/NXP/SC16IS750IBS.html datasheet] linked to on the [[Hardware]] page for reference. From that datasheet, for the structure of the I2C register address u8: "Bit 0 is not used, bits 2:1 select the channel, bits 6:3 select one of the UART internal registers. Bit 7 is not used with the I2C-bus interface, but it is used by the SPI interface to indicate a read or a write operation."
See the [http://www.alldatasheet.net/datasheet-pdf/pdf/347838/NXP/SC16IS750IBS.html datasheet] linked to on the [[Hardware]] page for reference. From that datasheet, for the structure of the I2C register address u8: "Bit 0 is not used, bits 2:1 select the channel, bits 6:3 select one of the UART internal registers. Bit 7 is not used with the I2C-bus interface, but it is used by the SPI interface to indicate a read or a write operation."
== Device 14 ==
Used by [[Config_Services|Cfg]]-sysmodule via the i2c::EEP service. This is presumably EEPROM going by the service name.
The Cfg-module code which loads the [[Flash_Filesystem|CCAL]] file from NAND will load it from I2C instead, if a certain state flag is non-zero. HMAC/hash verification is skipped when the CCAL was loaded from I2C.
== Device 15 ==
== Device 15 ==