NWMUDS:GetApplicationData
RequestEdit
| Index Word | Description |
|---|---|
| 0 | Header code [0x00110040] |
| 1 | Size |
The following is located 0x100-bytes after the beginning of the above command buffer:
| Index Word | Description |
|---|---|
| 0 | (Size<<14) | 2 |
| 1 | Pointer to output buf |
ResponseEdit
| Index Word | Description |
|---|---|
| 0 | Header code |
| 1 | Result code |
| 2 | Actual data size. |
DescriptionEdit
This loads the appdata from the current beacon. This can only be used while connected to the network(host/client).
If the input size is larger than 0x300, NWM-module uses size 0x300 instead. The actual appdata-copying code just verifies that appdata_size is <= input_size, on failure result-code 0x0 is returned with output actual_size=0(since no data was copied).